40020 Stepper Motor Control SMC: Motor initialization has failed [<Name of the stepper motor>] Gravure Japanese_Newspaper_OEM_Engine Magnus_VLF Thermoflex Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The stepper failed to initialize properly. Initailizing the stepper involves writing the output gain, microstep rate, and alternate sensor invert mask to the remote controller, as well setting the direction mode and update mode. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Firmware bug (invalid parameters). Can communication failure. Name of the stepper motor. 13-Aug-2003 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:21 2008 PST